1. Brushed stainless steel and glacier white, epoxy-coated steel exterior with blue accents.

2. Glass lid.

3. Lid latch with safety sensor.

4. Phenol-free lid gasket.

5. PTFE-coated aluminum chamber with Hastelloy shaft.

6. 300-watt heater.

7. Microprocessor-controlled programming for run time from 1 to 999 minutes, heat from OFF to HI (100° C) in one degree increments, and heat time from 1 to 999 minutes. Memory stores 1 to 9 programs.

8. LCD for display of program number, actual and set point temperature, heater time remaining, and run time remaining.

9. Control panel with RUN/STOP button, PREHEAT button, set point SELECT button, increase/decrease buttons, and 3 Quick-Start buttons.

10. Centrifugal motion is provided by a brushless motor capable of achieving up to 1725 rpm.

11. Quick-Stop System to stop vacuum pump, open valve to bleed air into the chamber and stop the rotor within seconds after time expires or RUN/STOP button is pressed.

12.  Automatic vacuum release valve.

13. Built-in vacuum delay allows rotor to achieve speed before applying vacuum.

14. Audible alarm to signal completion of set point run time.

15. 1/2" OD aluminum hose fitting for connection to vacuum tubing. Vacuum pump is not included.

16.  Vacuum port with quick disconnect fitting for 1/4" ID tubing.

17. 115 volt models have a 115 volt electrical receptacle on the back to connect accessory vacuum pump to the system.

18.  230 volt models have a reverse IEC electrical receptacle on the back to connect accessory vacuum pump to the system.

19. 115 volt models have a 6.5-foot, 3-wire cord with NEMA 5-15 plug.

20. 230 volt models have an 8-foot cord with NEMA 6-15 plug.

21. Overall dimensions with closed lid: 14.7" wide x 19.3" deep x 11.7" high (37.3 x 49.0 x 29.7 cm).

22. Actual weight 45 lbs. (20 kg). Shipping weight 65 lbs. (29 kg).